Problem with capillary force -- CFD Online Discussion Forums

April 26, 2014, 10:49	Problem with capillary force	#1
30na New Member Join Date: Jan 2014 Posts: 26 Rep Power: 12	Hi there, So i am trying to simulate a rotating vessel with capillary force . The results are fine up to a certain point , but then the time step increases dramatically and when i check the results in paraFoam, the results seem really strange . I ran the same simulation without the capillary force and there was no problem . Does anybody know what the problem is ? by the way capillary angel is 45 degrees

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
lift force problem with Flow around a cylinder	Scabbard	OpenFOAM Running, Solving & CFD	2	July 21, 2014 04:19
CFX Total force problem	momozzzz	CFX	1	July 15, 2011 09:54
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
Two-phase air water flow problems by activating Wall Lubrication Force	challenger85	CFX	5	November 5, 2009 05:44
Urgently Need the code of Lift force and VM force	Kai Yan	Main CFD Forum	0	July 16, 2008 07:07

All times are GMT -4. The time now is 07:29.