 |
 |
 |
|
|
|
[Sponsors] | ||||
May 18, 2014, 23:35
|
dQ XiFoam
|
#1 |
|
New Member
remi
Join Date: May 2014
Location: China
Posts: 26
Rep Power: 12  |
Hello everyone,
I am currently using XiFoam and I would like to know if there was a way to calculate the heat release at it is done in reactingFoam. I tried to change the createField.H of "myXiFoam", without success. Is this because the solver used in XiFoam is not ODEchemistrysolver? Regards, Remi |
|
|
|
|
|
April 21, 2021, 11:23
|
HRR in XiFoam
|
#2 |
|
New Member
donwang1985
Join Date: Jan 2020
Posts: 4
Rep Power: 7 |
Hello Formers(especially for XiFoam users)
When we use XiFoam to simulate premixed combustion,how can we characterize the Heat Release Rate(HHR)? It seems that the Qdot is not suitable for the XiFoam. The XiFoam always prompt like that:“FOAM FATAL ERROR： lookup of combustion properties from objectRegistry region0 successful，but it is not a combustionModel，it is a dctionary“ |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| XiFoam lean-premixed combustion instabilities | remir | OpenFOAM Running, Solving & CFD | 8 | April 15, 2016 08:31 |
| How to call inhomogeneousMixture.func() in XiFoam solver? | chenhu | OpenFOAM Running, Solving & CFD | 1 | March 19, 2015 05:02 |
| XiFoam simulation error | raysark | OpenFOAM Running, Solving & CFD | 4 | March 18, 2013 17:02 |
| XiFoam floating point error..mut error? | achinta | OpenFOAM | 8 | July 31, 2012 04:48 |
| [Gmsh] trouble with les model in XiFoam after convertion gmshTofoam? | lfgmarc | OpenFOAM Meshing & Mesh Conversion | 0 | May 24, 2011 23:35 |
Linear Mode
