PatchInjection crashes in parallel
 

Dear all,

I am simulating a flow with the lagrangian solver sprayFoam. If I inject particles with the coneInjection model I can run in parallel my case, but if I use the patchInjection model it crashed at the beginning, even though it works in serial. I thought that the problem was that my domain was cut exactly where the injector was but I verified that is not. Does someone have the same problem of know how to fix this?

Thanks,
Marco

I also encounter the same problem. Have you solved your problem? Could you tell us? Thank you very much!!!

Best regards,
Xu

Hello everyone,
Has anyone solved this issue? Even I'm facing a similar issue in that, my case runs in serial mode but crashes after a few iterations in parallel when the preferred injection mode is patchInjection.

Best,
Scram_1