Interface surface of liquid (interFoam)

przesmak · September 17, 2014, 09:20

Hi everyone,

I have a problem, how to get the information about value of interface boundary surface area. I am change the interFoam solver a bit, and I need the value of the free surface to calculation the energy transfer between two phases.

I already tried to use swak4Foam isoSurface, but I don't have any idea, how to implement such formulas to my runtime calculations.

Does anybody have a proposition how to solve this problem ?

I will be appreciate for some help.

raunakbardia · March 12, 2015, 14:34

Did you get any solution to this? I need to implement a similar calculation of surface area for liquid-gas interface and I would really appreciate some help.

Thanks.

September 17, 2014, 09:20	Interface surface of liquid (interFoam)	#1
przesmak New Member Join Date: Mar 2014 Posts: 5 Rep Power: 13	Hi everyone, I have a problem, how to get the information about value of interface boundary surface area. I am change the interFoam solver a bit, and I need the value of the free surface to calculation the energy transfer between two phases. I already tried to use swak4Foam isoSurface, but I don't have any idea, how to implement such formulas to my runtime calculations. Does anybody have a proposition how to solve this problem ? I will be appreciate for some help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
Interfoam... free surface simulation urgent	lostin4ever	Main CFD Forum	4	October 12, 2010 08:29
[Gmsh] boundaries with gmshToFoam‏	ouafa	OpenFOAM Meshing & Mesh Conversion	7	May 21, 2010 12:43
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

March 12, 2015, 14:34		#2
raunakbardia Member Raunak Bardia Join Date: Jan 2015 Posts: 32 Rep Power: 12	Did you get any solution to this? I need to implement a similar calculation of surface area for liquid-gas interface and I would really appreciate some help. Thanks.