Weird thing in AMI boundary condition in OpenFOAM

mortezahdr · December 3, 2018, 14:49

Hello,

I have noticed a weird thing about sliding-mesh problems in OpenFOAM. Consider two cases:
1. You use snappyHexmesh, topoSet and createPatch to build the mesh, cell-zones and boundary conditions.
2. You generate the mesh outside the OpenFOAM (like Pointwise, etc) and then topoSet and createPatch.

The weird thing is that following method 1, you do not need to specify AMI patch in initialization files in 0 folder (U, p, nut, omega,k). You may run the case and OpenFOAM does not complain about that. But following method 2, OpenFOAM says:
Cannot find patchField entry for AMI1 (or whatever the AMI patch name is).
while in both cases, you have the two AMI patches in your boundary file (after running createPatch). Does anybody know the reason?

mortezahdr · December 3, 2018, 15:31

The problem is solved. The reason was including the following lines in OpenFOAM's case setup:

//- Set patchGroups for constraint patches
#includeEtc "caseDicts/setConstraintTypes"

December 3, 2018, 14:49	Weird thing in AMI boundary condition in OpenFOAM	#1
mortezahdr Member Morteza Join Date: Jan 2018 Posts: 30 Rep Power: 8	Hello, I have noticed a weird thing about sliding-mesh problems in OpenFOAM. Consider two cases: 1. You use snappyHexmesh, topoSet and createPatch to build the mesh, cell-zones and boundary conditions. 2. You generate the mesh outside the OpenFOAM (like Pointwise, etc) and then topoSet and createPatch. The weird thing is that following method 1, you do not need to specify AMI patch in initialization files in 0 folder (U, p, nut, omega,k). You may run the case and OpenFOAM does not complain about that. But following method 2, OpenFOAM says: Cannot find patchField entry for AMI1 (or whatever the AMI patch name is). while in both cases, you have the two AMI patches in your boundary file (after running createPatch). Does anybody know the reason?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM 4.0 Released	CFDFoundation	OpenFOAM Announcements from OpenFOAM Foundation	2	October 6, 2017 05:40
Out File does not show Imbalance in %	Mmaragann	CFX	5	January 20, 2017 10:20
Compressor Simulation using rhoPimpleDyMFoam	Jetfire	OpenFOAM Running, Solving & CFD	107	December 9, 2014 13:38
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28
Low Mixing time Problem	Mavier	CFX	5	April 29, 2013 00:00

December 3, 2018, 15:31		#2
mortezahdr Member Morteza Join Date: Jan 2018 Posts: 30 Rep Power: 8	The problem is solved. The reason was including the following lines in OpenFOAM's case setup: //- Set patchGroups for constraint patches #includeEtc "caseDicts/setConstraintTypes"