Problem with vectorSnapshots OF extend 3.1

behzad-cfd · July 20, 2015, 10:33

Hi everyone

I'm using open Foam extend 3.1. i was trying to apply vectorSnapshots on my LES case with 2 million 3D mesh and 201 snapshots.it took couple of hours and finally gives error below:

Code:

Field error: absolute = 40.011996206364 relative = 0.0063375855132624 measure = 6313.4447847106
Field error: absolute = 45.532431968661 relative = 0.0072020694409597 measure = 6322.1317625332
Field error: absolute = 51.263247724471 relative = 0.0080975378589948 measure = 6330.7203519312
Field error: absolute = 60.238597807771 relative = 0.0094962337055002 measure = 6343.4198942346
Writing POD base for Time = 0

End

*** Error in `vectorSnapshots': double free or corruption (out): 0x00007fff70217150 ***
Aborted (core dumped)

whats wrong?

best regards in advance

behzad-cfd · July 27, 2015, 05:13

Hi guys

It's probably a bug for OpenFOAM extend 3.1. I tested same case on 1.6 Extend and worked like a charm.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to extend FSI 2D codes to 3D, need advises	abouziar	Main CFD Forum	1	May 30, 2008 05:08
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 07:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 20:13
extremely simple problem... can you solve it properly?	Mikhail	Main CFD Forum	40	September 9, 1999 10:11
Is this problem well posed?	Thomas P. Abraham	Main CFD Forum	5	September 8, 1999 15:52

July 27, 2015, 05:13		#2
behzad-cfd Member behzad Ghasemi Join Date: Sep 2013 Location: Iran Posts: 56 Rep Power: 14	Hi guys It's probably a bug for OpenFOAM extend 3.1. I tested same case on 1.6 Extend and worked like a charm.