|
[Sponsors] |
January 19, 2016, 08:37 |
OpenFoam parallel running log issue
|
#1 |
Member
gereksiz
Join Date: Mar 2015
Posts: 42
Rep Power: 11 |
Hello,
When I run something parallel, there isn't anything written in log file, however, when it's serial there isn't any problem. I'm using this command. mpirun -np 2 simpleFoam -parallel > log & I have the log file only after it's completed. It's really annoying, because I can't check the residuals or how much time I need. I checked the forum a bit, but I couldn't find any solution or see anybody had this problem. Regards, |
|
January 19, 2016, 08:59 |
|
#2 |
Member
Pascal Balz
Join Date: Feb 2015
Location: Germany
Posts: 44
Rep Power: 11 |
Hi,
Code:
mpirun -np 2 simpleFoam -parallel | tee log.simpleFoam
__________________
Regards, Pascal |
|
January 19, 2016, 09:12 |
|
#3 |
Member
gereksiz
Join Date: Mar 2015
Posts: 42
Rep Power: 11 |
it works very well, thank you very much!
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error running simpleFoam in parallel | Yuby | OpenFOAM Running, Solving & CFD | 14 | October 7, 2021 04:38 |
openfoam pow() fails when running parallel | Carlen | OpenFOAM Programming & Development | 9 | February 23, 2015 02:02 |
Suggestion for a new sub-forum at OpenFOAM's Forum | wyldckat | Site Help, Feedback & Discussions | 20 | October 28, 2014 09:04 |
parallel running issue in ansys 14 fluent | ade4921 | FLUENT | 3 | March 6, 2014 05:35 |
Running Error using Compressible OpenFoam Parallel mode | dhendria | OpenFOAM Running, Solving & CFD | 0 | February 13, 2014 20:53 |