|March 7, 2016, 04:25||
non-matching boundary problem
Join Date: Dec 2015
Posts: 9Rep Power: 3
I have a problem matching two cellzones.
My geometry is a rotor-impeller combination.
The rotor has two blades and the impeller seven.
I just want to simulate the half rotor and one seventh of the impeller.
Is there any way to use the cyclicAMI boundary condition?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Low torque values on Screw Turbine||Shaun Waters||CFX||34||July 23, 2015 08:16|
|Radiation interface||hinca||CFX||15||January 26, 2014 18:11|
|domain imbalance for enrgy equation||happy||CFX||14||September 6, 2012 01:54|
|[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6||prashanthreddyh||ANSYS Meshing & Geometry||1||December 20, 2011 01:35|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 16:55|