|
[Sponsors] |
March 7, 2016, 03:25 |
non-matching boundary problem
|
#1 |
New Member
A Z
Join Date: Dec 2015
Posts: 16
Rep Power: 10 |
Hey,
I have a problem matching two cellzones. My geometry is a rotor-impeller combination. The rotor has two blades and the impeller seven. I just want to simulate the half rotor and one seventh of the impeller. Is there any way to use the cyclicAMI boundary condition? Regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Low torque values on Screw Turbine | Shaun Waters | CFX | 34 | July 23, 2015 08:16 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
domain imbalance for enrgy equation | happy | CFX | 14 | September 6, 2012 01:54 |
[GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |