Maximum number of iterations exceeded - bump
1 Attachment(s)
Hi All,
This seems to be a problem a few people have had without any real explanation. I am trying to create a simple turbulent flow down a pipe using a K-epsilon model. I have used simpleFoam and the pipe flow has been successful, however when I try to use multi-regions I get this error. I cannot seem to understand why after time step 20 the solver starts to cause issues and eventually the maximum number of iterations become exceeded. I have noticed shortening the pipe has increased the amount of acceptable time steps and relaxing h when using this case in a heat transfer equation as suggested in another post. Any suggestions would be greatly appreciated as this issue has plagued me for a good month now. Cheers, Seddon |
All times are GMT -4. The time now is 10:40. |