 |
 |
 |
|
|
|
[Sponsors] | ||||
July 17, 2018, 12:41
|
Immersed-Boundary
|
#1 |
|
New Member
Johannes
Join Date: Jul 2018
Posts: 6
Rep Power: 7  |
Hi everybody,
can someone send me a case where the immersed boundaries in foam-extend-4.0 or foam-extend-4.1 works fine. I can run a few cases, but just ones with a simple geometry. When the geometry and specially the ftr/stl-file become more complex the simulation abords. So, how do you generate your stl-file? (I do it with Salome) And what solver do you use? (pimpleDyMIbFoam? ) Greetings |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| Centrifugal fan-reverse flow in outlet lesds to a mass in flow field | xiexing | CFX | 3 | March 29, 2017 10:00 |
| Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
| Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 11:19 |
| Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Linear Mode
