 |
 |
 |
|
|
|
[Sponsors] | ||||
problem in rhoSimpleFoam:Maximum number of iterations exceeded |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 29, 2016, 04:47
|
problem in rhoSimpleFoam:Maximum number of iterations exceeded
|
#1 |
|
New Member
Bo Kong
Join Date: Oct 2016
Location: China
Posts: 22
Rep Power: 11  |
Hi everyone,
I am a new to openFoam. I simulated a transonic flow in a nozzel using rhoSimpleFoam. The case was stopped after about 1000 iterations and reported errors: --> FOAM FATAL ERROR: Maximum number of iterations exceeded From function thermo<Thermo, Type>::T(scalar f, scalar T0, scalar (thermo<Thermo, Type>::*F)(const scalar) const, scalar (thermo<Thermo, Type>::*dFdT)(const scalar) const, scalar (thermo<Thermo, Type>::*limit)(const scalar) const) const in file /opt/OpenFOAM/OpenFOAM-2.3.x/src/thermophysicalModels/specie/lnInclude/thermoI.H at line 76. FOAM aborting I have checked the mesh which is ok. Could you tell me how to solve this problem? |
|
|
|
|
|
| Tags |
| iterations exceeded, rhosimplefoam error |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| a problem with convergence in buoyantSimpleFoam | skuznet | OpenFOAM Running, Solving & CFD | 6 | November 15, 2017 13:12 |
| High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 14:40 |
| Floating point exception error | lpz_michele | OpenFOAM Running, Solving & CFD | 53 | October 19, 2015 03:50 |
| Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 19:17 |
| Differences between serial and parallel runs | carsten | OpenFOAM Bugs | 11 | September 12, 2008 12:16 |
Linear Mode
