|
[Sponsors] |
June 13, 2017, 04:04 |
Mesh Morphing!
|
#1 |
Member
OpenFoam
Join Date: Jun 2016
Posts: 82
Rep Power: 10 |
Hi All
I have been reading about mesh moving and am kind looking for some help because either the tutorials are old or missing case files. I have a C-D nozzle that I created using Gmsh utility and then I parametrized the shape using a fourth order polynomial. Now, I am aiming to couple DAKOTA with simpleFoam to do some optimization studies for the C-D nozzle but my issue is to find an efficient way to make the mesh moves according to the design variables. I have read some tutorials created by Chalmers but most of them are old. I am using OpenFoam 2.3.2. Can someone bring up to speed by suggesting some good tutorials? Thanks in advance, |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 06:03 |
Mesh morphing in parallel: procBoundary faces don't match after many iterations | jmf | OpenFOAM Programming & Development | 0 | February 4, 2017 14:22 |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 17:59 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
Mesh Morphing in CFX ??? | vmlxb6 | CFX | 10 | March 9, 2011 15:59 |