 |
 |
 |
|
|
|
[Sponsors] | ||||
November 17, 2017, 04:35
|
Processor 0 not working
|
#1 |
|
Member
Vishwesh Ravi Shrimali
Join Date: Aug 2017
Posts: 43
Rep Power: 10  |
Hi!
I was working on Aurelia's work on VOF-LPT conversion and had used the master processor to carry out some centralized work. It was only recently that I realized that even though when a part of code was NOT inside the condition (for master processor), it was running via master processor only. Making my solver crash... And now, as of a sudden, the entire processor 0 has stopped working. I have tried adding Pout statements to check which processor is working, I used if (UPstream::Master()) to see if master processor was working but it's not. Does anyone have any clue why this might be happening? Thanks |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is the subsetMotionSolver working in parallel? | Arnoldinho | OpenFOAM Running, Solving & CFD | 7 | April 27, 2016 05:38 |
| OpenFoam 1.7.1 in Ubuntu 10.04 won't start working | Leech | OpenFOAM Installation | 8 | August 10, 2014 21:42 |
| DPM parallel is not working but serial is working | johnwinter | FLUENT | 1 | March 27, 2012 03:01 |
| Working directory | mgonzalo | FLUENT | 1 | November 11, 2011 11:05 |
| viewing cfx post while working on cfx solver manager | HMR | CFX | 5 | March 9, 2011 23:33 |
Linear Mode
