 |
 |
 |
|
|
|
[Sponsors] | ||||
How to choose correct debugSwitch? (Floating point exception error) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 26, 2018, 15:26
|
How to choose correct debugSwitch? (Floating point exception error)
|
#1 |
|
Senior Member
Deep
Join Date: Oct 2017
Posts: 180
Rep Power: 10  |
Hello!
I have a very simple question. How to choose the correct debugSwitch? I am aware of the wiki page and the debugging document by Nilsson (Chamlers). The OF user guide gives some hints but those at best minimal. So basically I haven't found a source that describes what each of those debugSwitches do. So my question is: How to choose the correct debug switch for one's need? This is also in reference to an error I am getting with rhoCentralFoam: Thread here. |
|
|
|
|
|
April 12, 2018, 07:27
|
|
#2 |
|
Senior Member
Deep
Join Date: Oct 2017
Posts: 180
Rep Power: 10 |
Would appreciate any help with this.
Thanks |
|
|
|
|
|
|
| Tags |
| debug, debugswitch, openfoam 5.x, rhocentrafoam |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| long error when using make-install SU2_AD. | tomp1993 | SU2 Installation | 3 | March 17, 2018 07:25 |
| Mesquite - Adaptive mesh refinement / coarsening? | philippose | OpenFOAM Running, Solving & CFD | 94 | January 27, 2016 10:40 |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 19:00 |
| ParaView for OF-1.6-ext | Chrisi1984 | OpenFOAM Installation | 0 | December 31, 2010 07:42 |
| [Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 03:27 |
Linear Mode
