|
printstack error caused by subsetMesh error
2 Attachment(s)
Hi everyone, I faced printstack error when running pimpleFoam. I saw some posts said that it may be caused by division of 0 but I didn't set 0 value for any fields except nut.
Attached is link of my input files. https://www.dropbox.com/sh/ea5auq83u...9ZzX7N7Sa?dl=0 This probably caused by bad mesh. So I checkMesh but the result is ok and last time step showed fail 1 mesh. However, foamToVTK showed that my cellSets, eg: carExtCS (a hollow box) is ok before that. But it became inappropriate after subSet Mesh. Attached picture is cellSet carExtCS before and subsetMesh Attachment 62410 Attachment 62411 May I get some help on this? How should i subsetMesh to delete unwanted region to make a hollow space within my domain? Thanks a lot for your time to read through this :) Below is the output when run simulation https://www.dropbox.com/s/xu4hljpr7l...blockMesh?dl=0 |
| All times are GMT -4. The time now is 10:43. |