|
[Sponsors] |
DNS: crashes after a few iterations due to rising Courant number |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 8, 2016, 07:44 |
DNS: crashes after a few iterations due to rising Courant number
|
#1 |
New Member
Join Date: Jul 2014
Posts: 2
Rep Power: 0 |
Hello!
I am running DNS of a pipe flow and I am facing the following problem: The Courant number starts at a value lower then one, but as iterations advances, it increases and my simulation blows. I am using cyclic BC at inlet and outlet. Thanks! |
|
March 13, 2016, 14:09 |
|
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,975
Blog Entries: 45
Rep Power: 128 |
Quick comment: Please follow the instructions given here: How to give enough info to get help
|
|
November 4, 2018, 07:09 |
|
#3 |
Senior Member
Jianrui Zeng
Join Date: May 2018
Location: China
Posts: 157
Rep Power: 7 |
Dear milena,
I am also dealing with DNS in pipe flow,have you found the answer? Any advice or guide about DNS will be highly appreciated. Regards, Calf. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wrong fluctuation of pressure in transient simulation | caitao | OpenFOAM Running, Solving & CFD | 2 | March 5, 2015 21:33 |
Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 18:17 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |