Doubts about using solver MPPIC to form stationary particle pile
Hello,
I am trying to build my case using the solver MPPICFoam for my study case, consisting in building a small pile of ash (stationary) and verify the behavior with different flow velocity, to validate with wind tunnel experiments. I can't find much information regarding the solver online, and therefore decided to post my doubts below: 1. Is it possible to change the particles diameter? (i.e.: above 1 mm). I have been testing it, but can't see any difference in ParaView. 2. Is it possible to create an initial stationary particle pile, using the file KinematicCloudPositions? Thanks in Advance. |
check it out
|
All times are GMT -4. The time now is 12:13. |