 |
 |
 |
|
|
|
[Sponsors] | ||||
January 7, 2023, 01:08
|
pimpleFoam Crash
|
#1 |
|
New Member
RAKESH T V
Join Date: May 2013
Posts: 1
Rep Power: 0  |
Hi,
I am studying the effect of propeller wash on horizontal and vertical stabilizers of an aircraft. First of all i am not able to generate a perfect mesh on my geometry. There are 7 skewed cells at the tail region. I proceeded with pimpleFoam but the solver crashed after some iterations. I am confused whether the problem is it with meshing or with solver inputs, because i was able to increase the iteration level by changing the relaxation parameters. If anybody has any suggestion to solve my problem please help me in this. |
|
|
|
|
 |
| Tags |
| mesh generation, pimplefoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pimpleFoam runs slower than rhoPimpleFoam | Kosuke Seto | OpenFOAM Running, Solving & CFD | 3 | May 27, 2023 14:12 |
| Running pimpleFoam in steady state | trailer | OpenFOAM Running, Solving & CFD | 6 | January 24, 2023 03:07 |
| pisoFoam and pimpleFoam are unstable in foam-extend 4.0/4.1 (misunderstanding ?) | Kombinator | OpenFOAM Running, Solving & CFD | 4 | January 14, 2021 04:10 |
| pimpleFoam crash | WUYing | OpenFOAM Running, Solving & CFD | 1 | June 26, 2020 17:30 |
| Crash with renumberMesh and pimpleFoam LES | jmt | OpenFOAM Running, Solving & CFD | 0 | December 4, 2019 15:31 |
Linear Mode
