 |
 |
 |
|
|
|
[Sponsors] | ||||
October 21, 2020, 07:14
|
CyclicAMI & SimpleFoam results residuals =1
|
#1 |
|
New Member
Konstantinos Polyzos
Join Date: Aug 2020
Posts: 2
Rep Power: 0  |
Hello,
I am trying to conduct a DDES simulation of an SUV with fully detailed rims. In order to set rotation to the rims during the transient simulation, I must add CyclicAMI faces that will split the stationary from the moving volume , and will allow the communication of the interior with exterior volume and vice-versa. I would like to start the transient simulation from a converged steady state one. However, the steady state simulation with cyclicAMI faces at the rims results in residuals near to 1. Could anyone give me any advice on that ? |
|
|
|
|
 |
| Tags |
| cycli ami, moving mesh, openfoam 1.7.x, rotating rims, sliding mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| simpleFoam - wrong results? | Zibi | OpenFOAM Running, Solving & CFD | 26 | October 9, 2020 12:21 |
| time step continuity problem in VAWT simulation | lpz_michele | OpenFOAM Running, Solving & CFD | 5 | February 22, 2018 19:50 |
| SimpleFOAM results way off from measurements and analytical calculation | Deagle | OpenFOAM Running, Solving & CFD | 1 | December 14, 2016 03:07 |
| SimpleFoam results as initial condition to rhoSimpleFoam | marcelorl | OpenFOAM Pre-Processing | 5 | March 7, 2014 10:08 |
| Weird results k-epsilon with simpleFoam | Alfalfa | OpenFOAM Running, Solving & CFD | 10 | January 24, 2014 18:05 |
Linear Mode
