Problem with reconstructPar

hellonihaoma · December 30, 2020, 05:40

Hi all,

I am currently doing the wind driven rain simulation. I hv done the wind simulation and then I used this wind profile to run the rain simulation. The rain was converged but failed to reconstruct.

Here is the fatal message: ' Cannot find file "points" in directory "polyMesh" in times "0" to constant '.

I am looking forward to hearing from you soon. Thanks in advance!

dlahaye · December 30, 2020, 05:51

Check that mesh is there. Possibly used checkMesh to assure mesh is ok.

December 30, 2020, 05:40	Problem with reconstructPar	#1
hellonihaoma New Member Join Date: Dec 2020 Posts: 3 Rep Power: 6	Hi all, I am currently doing the wind driven rain simulation. I hv done the wind simulation and then I used this wind profile to run the rain simulation. The rain was converged but failed to reconstruct. Here is the fatal message: ' Cannot find file "points" in directory "polyMesh" in times "0" to constant '. I am looking forward to hearing from you soon. Thanks in advance!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Is COMSOL Multi Physics is suitable to solve complex flow problem?	steve lee	COMSOL	8	January 5, 2023 02:31
BuoyantBoussinesqSimpleFoam_Facing problem	Mondal131211	OpenFOAM Running, Solving & CFD	1	April 10, 2019 19:41
Mesh& steptime independant: conduction-convection problem	Fati1	Main CFD Forum	1	October 28, 2018 13:52
natural convection problem for a CHT problem	Se-Hee	CFX	2	June 10, 2007 06:29
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13

December 30, 2020, 05:51		#2
dlahaye Senior Member Domenico Lahaye Join Date: Dec 2013 Posts: 845 Blog Entries: 1 Rep Power: 19	Check that mesh is there. Possibly used checkMesh to assure mesh is ok.