Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Running, Solving & CFD

InterFoam using polyhedral mesh

Mark Forums Read

Reply

Search this Thread

January 18, 2021, 23:59	InterFoam using polyhedral mesh	#1
ranjith.ase New Member Ranjith Join Date: Oct 2020 Location: Bengaluru, INDIA Posts: 2 Rep Power: 0	Hello, I am interested to know if anyone has prior experience using polyhedral mesh for interFoam VOF calculations? I got good results using snappyHexMesh before, but geometry at the moment is quite complex and large. So I would like to use polyhedral mesh generated using commercial mesh generator. Thanks.

Reply

Tags

interfoam, openfoam, polyhedral mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water!	divergence	OpenFOAM Meshing & Mesh Conversion	0	January 23, 2019 04:17
Star CCM Overset Mesh Error (Rotating Turbine)	thezack	Siemens	7	October 12, 2016 11:14
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
[mesh manipulation] polyDualMesh, create a tetrahedral mesh from a polyhedral mesh	Martin80	OpenFOAM Meshing & Mesh Conversion	5	January 30, 2013 22:07
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

All times are GMT -4. The time now is 15:13.