|
[Sponsors] |
Wind Turbine Simulation with Periodic Boundaries without Sliding Interface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 28, 2021, 11:35 |
Wind Turbine Simulation with Periodic Boundaries without Sliding Interface
|
#1 |
New Member
Dimitris Vlastos
Join Date: Jun 2021
Posts: 1
Rep Power: 0 |
Hello, i'm trying to simulate a fully turbulent flow around 1/3 of a turbine rotor. Just the blade (no nacelle) with periodic boundaries.
I m using SRFSimple(or Pimple)Foam but i cant seem to get right results. Note: The mesh i m using in OpenFOAM has been validated with the use of another code. Does anybody have any experience in the subject? |
|
Tags |
openfoam, periodic, rotating frame, wind turbine |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FSI simulation of wind turbine blade using NLH method | Ko_Shine | Fidelity CFD | 3 | April 22, 2020 07:08 |
Can I achieve better convergence? | sheaker | CFX | 12 | September 19, 2019 15:36 |
Turbomachinery Mass imbalance | sheaker | CFX | 12 | September 5, 2019 08:09 |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
Boundary condition setting regarding turbine simulation using CFX | Lacerlacer | CFX | 11 | March 12, 2012 09:32 |