 |
 |
 |
|
|
|
[Sponsors] | ||||
How can I use porous media with rhoPimpleFoam in Openfoam v1912? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 27, 2021, 17:52
|
How can I use porous media with rhoPimpleFoam in Openfoam v1912?
|
#1 |
|
New Member
Ali Can
Join Date: Apr 2021
Posts: 28
Rep Power: 6  |
I have been studying csvity flow problem and I would like to define porous surface aft wall of the csvity? Any suggestions??
Thanks in advance.. |
|
|
|
|
|
November 28, 2021, 12:01
|
|
#2 |
|
Senior Member
Yann
Join Date: Apr 2012
Location: France
Posts: 1,360
Rep Power: 33 |
Hi,
Porous media are usually defined using the explicitPorositySource in fvOptions. You first need to define a cellZone corresponding to your porous media volume. Here is tutorial using it with rhoPimpleFoam : angledDuctLTS Yann |
|
|
|
|
|
|
November 28, 2021, 14:01
|
|
#3 |
|
New Member
Ali Can
Join Date: Apr 2021
Posts: 28
Rep Power: 6 |
Thank you very much for your answer, it was very helpful.
|
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Frequently Asked Questions about Installing OpenFOAM | wyldckat | OpenFOAM Installation | 4 | December 16, 2025 09:40 |
| OpenFOAM simulation for packed bed porous media. | Ash Kot | OpenFOAM Running, Solving & CFD | 2 | March 18, 2021 07:57 |
| OpenFOAM course for beginners | Jibran | OpenFOAM Announcements from Other Sources | 2 | November 4, 2019 09:51 |
| How to set mixed-wet conditions in two-dimensional porous media in OpenFOAM? | xiaolianwei | OpenFOAM Pre-Processing | 0 | August 22, 2019 00:19 |
| How to contribute to the community of OpenFOAM users and to the OpenFOAM technology | wyldckat | OpenFOAM | 17 | November 10, 2017 16:54 |
Linear Mode
