 |
 |
 |
|
|
|
[Sponsors] | ||||
SHM refinementSurfaces and simpleFoam divergence |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 26, 2022, 14:04
|
SHM refinementSurfaces and simpleFoam divergence
|
#1 |
|
New Member
GS
Join Date: Sep 2018
Posts: 21
Rep Power: 7  |
I have a case that I ran with simpleFoam. The results were not great, so I tried changing the refinementSurfaces levels from (5 5) to (6 8) in snappyHexMesh. The new mesh did not show any problems in checkMesh, but when I ran simpleFoam again, it diverged in 60 steps. Any suggestions?
|
|
|
|
|
|
March 26, 2022, 14:36
|
|
#2 |
|
Senior Member
Herpes Free Engineer
Join Date: Sep 2019
Location: The Home Under The Ground with the Lost Boys
Posts: 932
Rep Power: 12 |
my suggestions:
How to give enough info to get help https://stackoverflow.com/help/minim...ucible-example
__________________
The OpenFOAM community is the biggest contributor to OpenFOAM: User guide/Wiki-1/Wiki-2/Code guide/Code Wiki/Journal Nilsson/Guerrero/Holzinger/Holzmann/Nagy/Santos/Nozaki/Jasak/Primer Governance Bugs/Features: OpenFOAM (ESI-OpenCFD-Trademark) Bugs/Features: FOAM-Extend (Wikki-FSB) Bugs: OpenFOAM.org How to create a MWE New: Forkable OpenFOAM mirror |
|
|
|
|
|
|
March 27, 2022, 17:29
|
|
#3 |
|
New Member
GS
Join Date: Sep 2018
Posts: 21
Rep Power: 7 |
I have 2-D airfoil at low speed, so incompressible. I am using OF 2006.
My case files are too big, even compressed and leaving out the polyMesh files, so I am attaching what seem to be the most relevant. |
|
|
|
|
|
|
| Tags |
| divergence problem, refinementsurfaces, simplefoam |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SimpleFoam stops after 1 step with no errors | Bob Tipton | OpenFOAM Running, Solving & CFD | 4 | October 26, 2020 04:01 |
| error::printStack simpleFoam flowchannel | Floxi | OpenFOAM Running, Solving & CFD | 5 | October 10, 2016 04:21 |
Linear Mode
