MPPICFoam failed lookup of turbulenceProperties
2 Attachment(s)
Dear All,
I doing a test case where I simulate particles travelling along a narrow square duct with a porous baffle (cyclic boundary conditions) located roughly half way between the inlet and outlet using the MPPICFoam solver. (Note I am using OpenFOAM v2112). I have sorted out allot of issues but now I am stuck on the following error/problem when I am run the solver: "failed lookup of turbulenceProperties (objectRegistry region0) available objects of type turbulenceModel: (turbulenceProperties.air)" I have looked at other CFD-online posts but they unfortunately were not of much help in the end. Just a note: The simulation runs when I remove the porous baffle and cyclic boundary conditions and change the faceType (for the cellZone and faceZone setup) in snappyHexMesh from baffle to internal. I have attached my OpenFOAM case files using to two different archive formats for your convenience. I would truly appreciate your input on the matter. Regards, Charl |
All times are GMT -4. The time now is 15:37. |