interFoam BC for open water

EricS · September 13, 2022, 05:03

Hello everyone!

I'm trying to simulate the flow exiting a pipe placed around 3 meters under the sea level. The case is 2D but I'm having some problems with the boundary conditions for the "sea".

So far I set:
U
inlet -> flowRateInletVelocity
outlet -> inletOutletVelocity
p

inlet -> fixedFluxPressure
outlet -> zeroGradient
alpha
inlet -> fixedValue ... value 1

outlet -> variableHeightFlowRate

With those B.Cs the simulation diverges and I can't figure out what to change to make it works...
Do you have any guess or tip?

Thank you in advance

jherb · September 13, 2022, 19:04

You do not specify the pressure with your boundary conditions. Somewhere you need some kind of fixedValue boundary condition for p (or actually for p_rgh).

EricS · September 14, 2022, 05:41

Hi and thank you for your quick answer! Actually after some tests I was able to make it work by splitting the outlet patch in two and imposing flowRateOutletVelocity in the water patch!

September 13, 2022, 05:03	interFoam BC for open water	#1
EricS New Member Eric Segalerba Join Date: Dec 2021 Location: Italy Posts: 24 Rep Power: 4	Hello everyone! I'm trying to simulate the flow exiting a pipe placed around 3 meters under the sea level. The case is 2D but I'm having some problems with the boundary conditions for the "sea". So far I set: U inlet -> flowRateInletVelocity outlet -> inletOutletVelocity p inlet -> fixedFluxPressure outlet -> zeroGradient alpha inlet -> fixedValue ... value 1 outlet -> variableHeightFlowRate With those B.Cs the simulation diverges and I can't figure out what to change to make it works... Do you have any guess or tip? Thank you in advance

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Water level drop at outlet InterFoam solver	IngmarScholte	OpenFOAM Running, Solving & CFD	1	December 17, 2020 13:35
simulating water tank using interfoam	dpoly	OpenFOAM Running, Solving & CFD	0	March 26, 2020 16:18
Problem condensation/ evaporation (condensate water vapor)	bigfoot47	FLUENT	0	October 21, 2019 08:07
No liquid water exist in my Fuel Cell simulation	fatchang	FLUENT	19	October 15, 2018 14:27
(interfoam) shear stress at water air interface !	openfoam1	OpenFOAM	11	October 27, 2014 03:59

September 13, 2022, 19:04		#2
jherb Senior Member Joachim Herb Join Date: Sep 2010 Posts: 650 Rep Power: 21	You do not specify the pressure with your boundary conditions. Somewhere you need some kind of fixedValue boundary condition for p (or actually for p_rgh).

September 14, 2022, 05:41		#3
EricS New Member Eric Segalerba Join Date: Dec 2021 Location: Italy Posts: 24 Rep Power: 4	Hi and thank you for your quick answer! Actually after some tests I was able to make it work by splitting the outlet patch in two and imposing flowRateOutletVelocity in the water patch!