|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Maharghya Dyuti Das
Join Date: May 2023
Posts: 14
Rep Power: 2 ![]() |
Can anyone tell me how to do the simulation of centralized jet flow in fluidized bed, I have already done simulation of fluidized bed as per Taghipour et al. but I am unable to do the later one.
|
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
Humberto
Join Date: Mar 2021
Location: Brasil
Posts: 23
Rep Power: 4 ![]() |
I don't know if it will help, but since you weren't specific, I used the article by (LIU, HINRICHSEN) to study about fluidized bed, hope it helps.
LIU, Yefei; HINRICHSEN, Olaf. CFD modeling of bubbling fluidized beds using OpenFOAMŽ: Model validation and comparison of TVD differencing schemes. Computers & chemical engineering, v. 69, p. 75-88, 2014. |
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Maharghya Dyuti Das
Join Date: May 2023
Posts: 14
Rep Power: 2 ![]() |
Yes I have seen the paper but I am not understanding where to make changes in setFields or U.air so I can get the centralized gas flow. Pls can you help me.
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
pressure methode for hydrodynamic gas-solid bubbling fluidized bed? | rezakarimi | Main CFD Forum | 0 | June 7, 2020 06:58 |
eulerin bubbling gas-solid fluidized bed | rezakarimi | Main CFD Forum | 0 | May 28, 2020 03:48 |
modeling of two phase flow combustion in fluidized bed with MFIX | ehsan.m | Main CFD Forum | 0 | July 17, 2013 16:47 |
mass flow inlet condition is not properly specified in circulating fluidized bed | abinashlipun | FLUENT | 0 | April 19, 2013 02:28 |
Flow behaviour of fluidized bed | venkat | FLUENT | 1 | September 3, 2008 21:16 |