[Santhosh91]

Hello All,


I am simulating 3D emulsion flow behaviour in a micro T-junction channel.

I have experimental conditions that I am mimicking to obtain the geometry sizing and the boundary/initial conditions (see attachment). Only the inlet gas velocity is not provided.



However, I know the length of the emulsion. Therefore I adjusted the inlet gas velocity to obtain the same length as observed in the experiments. But the period of generation of the bubbles / mean velocity of the bubbles do not match with the experiments.


Does anybody had to model this type of problem and faced the same issue ? Or anyone has recommendations/advice/hints.


Any help would be greatly appreciated .
Thanks for your help and time!


Sincerely,
Santhosh