CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   OpenFOAM Running, Solving & CFD (https://www.cfd-online.com/Forums/openfoam-solving/)
-   -   Error when running pimpleFoam (https://www.cfd-online.com/Forums/openfoam-solving/253993-error-when-running-pimplefoam.html)

vassilisbak January 13, 2024 16:06
Error when running pimpleFoam
 
Hello everyone! i am having a hard time running the surfaceMountedCube case on openfoam2310.

Specifically, after running blockMesh i get the following error:

FOAM FATAL ERROR: (openfoam-2312)
Did not find a corresponding sourcePoint for every face centre

From void Foam::pointToPointPlanarInterpolation::calcWeights (const pointField&, const pointField&)
in file triSurface/triSurfaceTools/pointToPointPlanarInterpolation.C at line 155.

FOAM exiting


I have been scratching my head for a while... It would be amazing if someone had any ideas!

NotOverUnderated January 15, 2024 05:05
Quote:
Originally Posted by vassilisbak (Post 863077)
Hello everyone! i am having a hard time running the surfaceMountedCube case on openfoam2310.

Specifically, after running blockMesh i get the following error:

FOAM FATAL ERROR: (openfoam-2312)
Did not find a corresponding sourcePoint for every face centre

From void Foam::pointToPointPlanarInterpolation::calcWeights (const pointField&, const pointField&)
in file triSurface/triSurfaceTools/pointToPointPlanarInterpolation.C at line 155.

FOAM exiting


I have been scratching my head for a while... It would be amazing if someone had any ideas!
Hi,

Please provide more details about your case setup. The error message is too generic.

Regards

vassilisbak February 19, 2024 14:39
Hey,
Thanks for the advice! I moved on and am in fact making new mistakes.
:D


All times are GMT -4. The time now is 23:42.