|
[Sponsors] |
April 17, 2024, 09:03 |
Time-dependent boundary condition
|
#1 |
New Member
Ali Jraisheh
Join Date: Jun 2019
Location: Mumbai, India
Posts: 1
Rep Power: 0 |
Hi
I am trying to run a simulation with time-dependent back pressure (at the outlet), using rhoCentralFoam solver. It says in the manual that we can do this by using: outlet { type uniformFixedValue; uniformValue table ( (0 100) (5e-07 200) (1e-06 300) (1.5e-06 400) (2e-06 500) (2.5e-06 600) (3e-06 700) (3.5e-06 800) (4e-06 900) } The simulation runs for a few time steps with a constant back pressure (to achieve a steady-state case before varying the back pressure), and the moment it hits the time step at which the pressure starts changing, it diverges. I tried using a very low Courant number, and very low variation in pressure (probably 10 Pascals increment), but it always diverges. Does anyone have a solution for this? |
|
Tags |
boundary condition, openfoam 9, rhocentralfoam, time-dependent |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fixedValue boundary condition with a time dependent value | meth | OpenFOAM Pre-Processing | 11 | May 25, 2023 03:03 |
Postprocess: sampleDict works but creates no output folder | shock77 | OpenFOAM Post-Processing | 14 | November 15, 2021 09:27 |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 08:38 |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 05:13 |
plot over time | fferroni | OpenFOAM Post-Processing | 7 | June 8, 2012 08:56 |