|March 3, 2009, 10:22||
Hi I'm new to CFD and OpenF
Join Date: Mar 2009
Posts: 6Rep Power: 10
I'm new to CFD and OpenFoam and I need some help in defining correct boundary conditions on my test case.
I'm testing a case where constant volumetric flow goes through a contraction. I have created a mesh which consists from inlet, contraction and outlet. I would like to know how to specify the outlet condition so I will correctly see how the fluid's velocity is increased in the contraction. My inlet is of fixed value type with uniform velocity (0.1 m/s). Should I use the same for my outlet?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Density in icoFoam Densidad en icoFoam||manuel||OpenFOAM Running, Solving & CFD||8||September 22, 2010 04:10|
|IcoFoam and Contraction in Pipe||sami_lakka||OpenFOAM Running, Solving & CFD||0||March 3, 2009 10:18|
|simulate contraction part of wind tunnel||fadly||CFX||2||July 31, 2007 02:17|
|contraction part in wind tunnel||fadly||CFX||0||July 3, 2007 22:33|
|sudden expnasion and contraction losses||Babu||Main CFD Forum||1||February 10, 2005 08:36|