|September 23, 2008, 14:28||
I have been running a surface
Join Date: Mar 2009
Posts: 45Rep Power: 10
I have been running a surface piercing foil in rasInterFoam. The free surface forms correctly early in the simulation, but over time it looks like there is a reflection off the outlet patch that does not seem correct.
A tar'd copy of the case files is here foilFn19Case.tar.gz and some images showing the wave height contours plotted on the gamma = 0.5 iso-surface at time equal 0.4 where the free surface is forming nicely 0.40.png.gz and later at 7.25 sec 7.25.png.gz .
If someone could review the images and case files and point me in the right direction I would appreciate it.
I can email a small movie that is to big to post here if it would help.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Surface Piercing Foil||dkingsley||OpenFOAM Running, Solving & CFD||0||September 23, 2008 14:18|
|UDF for air gap in a foil bearing||Rishikesh||FLUENT||0||September 22, 2008 01:12|
|X-Foil!||mimi||Main CFD Forum||2||May 15, 2007 11:19|
|Freesurface piercing foil numerical wiggles in gamma isosurface||egp||OpenFOAM Running, Solving & CFD||8||May 2, 2007 08:59|
|Foil||Phil||FLUENT||7||November 19, 2002 05:30|