|
[Sponsors] |
September 23, 2008, 14:18 |
I have been running a surface
|
#1 |
Member
Dennis Kingsley
Join Date: Mar 2009
Location: USA
Posts: 45
Rep Power: 17 |
I have been running a surface piercing foil in rasInterFoam. The free surface forms correctly early in the simulation, but over time it looks like there is a reflection off the outlet patch that does not seem correct.
A tar'd copy of the case files is here and a small movie showing the wave height contours plotted on the gamma = 0.5 iso-surface is here . If someone could review the movie and case files and point me in the right direction I would appreciate it. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Surface Piercing Foil | dkingsley | OpenFOAM Running, Solving & CFD | 0 | September 23, 2008 14:28 |
UDF for air gap in a foil bearing | Rishikesh | FLUENT | 0 | September 22, 2008 01:12 |
X-Foil! | mimi | Main CFD Forum | 2 | May 15, 2007 11:19 |
Freesurface piercing foil numerical wiggles in gamma isosurface | egp | OpenFOAM Running, Solving & CFD | 8 | May 2, 2007 08:59 |
Foil | Phil | FLUENT | 7 | November 19, 2002 04:30 |