|
[Sponsors] |
Outlet boundary condition for pd in InterFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 19, 2008, 10:26 |
Hello,
I want to simulate a
|
#1 |
New Member
Vinay Ramohalli Gopala
Join Date: Mar 2009
Location: Netherlands
Posts: 13
Rep Power: 17 |
Hello,
I want to simulate a 2 dimensional channel Flow, with a small inlet on the left wall injecting water into the domain using interFoam. The complete right Wall is an outlet. For boundary condition at inlet I use gamma = 1 with a specified inlet velocity. At the outlet, I need to speicify a zero pressure boundary condition. As interFoam uses the modified pressure (pd), I cannot specify 0 for pd !! This works if the gravity is switched off, but how should I implement the outlet boundary condition whilst gravity is swtiched on ? Is there any other boundary condition that I can try at the outlet? Thanks in advance ! vinay |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Selective outlet boundary condition for InterFoam | caw | OpenFOAM Running, Solving & CFD | 5 | February 7, 2012 14:48 |
outlet boundary condition | Brian | FLUENT | 3 | June 20, 2007 08:24 |
VOF Outlet boundary condition in cfd - ace | JM | Main CFD Forum | 0 | December 15, 2006 09:07 |
Outlet boundary condition in channel flow solving with interFoam | liuzhw | OpenFOAM Running, Solving & CFD | 0 | November 29, 2005 22:07 |
Outlet boundary condition | CN | FLUENT | 6 | May 22, 2005 10:37 |