Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Running, Solving & CFD

Setup for sliding mesh in rhoSonicFoam

Mark Forums Read

Reply

Search this Thread

June 27, 2006, 00:15	Hi,all I am trying to build a	#1
ddydai New Member ddydai Join Date: Mar 2009 Posts: 3 Rep Power: 18	Hi,all I am trying to build a case for compressed fluid flow patern concerned with sliding mesh. Finished doing tutorial mixer2D,I only got to know to set the slider patch in icoFOAM,how can I setup the transfer-style sliding mesh case (shown in the fig. below)which can deal with the compressing fluids. Any tips or suggestions ? Regards ddydai

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sliding mesh setup for a mixing tank in Gambit	nycera	FLUENT	13	October 11, 2016 15:39
Oscillatory mesh motion setup mesh flux ERROR	jaswi	OpenFOAM Running, Solving & CFD	5	August 23, 2007 05:41
A Mesh or Solver setup problem	philippose	OpenFOAM Running, Solving & CFD	3	November 5, 2006 15:54
Setup for sliding mesh in rhoSonicFoam	ddydai	OpenFOAM Running, Solving & CFD	0	June 26, 2006 23:41
Dynamic Mesh setup problem	Jim	FLUENT	1	June 8, 2005 10:26

All times are GMT -4. The time now is 10:40.