Multiphase flow in bubbleFoam case

brahim · July 21, 2005, 10:45

hello,
I would like to add another one phase dispersed (solid) in the case of bubbleFoam i.e. a multiphase flow. Will know that I already tried to write the various formulations necessary and there remain to me some arguments by the way this subject.

thank's again

brahim · July 25, 2005, 11:06

hello,
I wanted to plot curves in 2d of some results, I tested with the instruction given by the OpenFoam documentation, but I do not have to succeed. if somebody has so there already plotted curves starting from OpenFoam.
greeting

mattijs · July 25, 2005, 14:07

If this is using the 'sample' utility: usually the problem is that

- the end points of the sampling line are not inside a cell.
- the sampling line goes along faces or edges. Just shift one of the endpoints with a very small amount.

Try the sampleDict in the stressedFoam/plateHole.

July 21, 2005, 10:45	hello, I would like to add a	#1
brahim New Member Brahim Aakti Join Date: Mar 2009 Location: Lucerne, Switzerland Posts: 23 Rep Power: 17	hello, I would like to add another one phase dispersed (solid) in the case of bubbleFoam i.e. a multiphase flow. Will know that I already tried to write the various formulations necessary and there remain to me some arguments by the way this subject. thank's again

July 25, 2005, 11:06	hello, I wanted to plot curve	#2
brahim New Member Brahim Aakti Join Date: Mar 2009 Location: Lucerne, Switzerland Posts: 23 Rep Power: 17	hello, I wanted to plot curves in 2d of some results, I tested with the instruction given by the OpenFoam documentation, but I do not have to succeed. if somebody has so there already plotted curves starting from OpenFoam. greeting

July 25, 2005, 14:07	If this is using the 'sample'	#3
mattijs Senior Member Mattijs Janssens Join Date: Mar 2009 Posts: 1,419 Rep Power: 26	If this is using the 'sample' utility: usually the problem is that - the end points of the sampling line are not inside a cell. - the sampling line goes along faces or edges. Just shift one of the endpoints with a very small amount. Try the sampleDict in the stressedFoam/plateHole.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Difference between bubblefoam and twophaseeulerfoam	ebaerow	OpenFOAM Running, Solving & CFD	3	March 14, 2009 06:55
KEpsilon in bubbleFoam and twoPhaseEulerFoam	vkaufmann	OpenFOAM Running, Solving & CFD	0	November 5, 2008 08:25
Test Case for Multiphase heat transfer	CFDtoy	Main CFD Forum	0	April 20, 2007 12:29
CVMcoefficient in bubblefoam	stephan	OpenFOAM Running, Solving & CFD	4	December 19, 2006 01:48
BubbleFoam alpha equation	alberto	OpenFOAM Running, Solving & CFD	9	September 21, 2005 01:33