|May 14, 2009, 13:16||
Problem with modified dieselEngineFoam
Join Date: Mar 2009
Location: Gembloux, Namur, Belgique
Posts: 13Rep Power: 10
I'm running a modified version of dieselEngineFoam where layering is implemented. I'm running it on a 2D axi-symmetric mesh made with the blockMesh tool.
When I'm running it with a grid of 60(large)x90(height) cells, all work fine. When I try to increase the number of cells over 90, I have this error message after a few steps:
Courant Number mean: 0.0051238 max: 0.179441
Crank angle = -174 CA-deg
deltaZ = 1.84629e-05 Piston at:0.0114478
Piston layering mode
Cell 2220 is marked as removed but still has faces. Cell faces:
4(4514 4515 4576 4575)
4(4636 4637 4698 4697)
From function Foam::autoPtr<Foam::mapPolyMesh> Foam:olyTopoChanger::changeMesh
const polyTopoChange& ref
in file polyTopoChange/polyTopoChanger/polyTopoChangerChangeMesh.C at line 620.
I don't understand where it comes from, does one of you have any suggestion ?
Thank you for your help !
|Thread||Thread Starter||Forum||Replies||Last Post|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Incoherent problem table in hollow-fiber spinning||Gianni||FLUENT||0||April 5, 2008 10:33|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|
|convergence problem||Trushar||Phoenics||5||August 27, 2002 23:40|