 |
 |
 |
|
|
|
[Sponsors] | ||||
May 26, 2009, 04:50
|
Periodic GGI, How to
|
#1 |
|
New Member
David Sponiar
Join Date: Mar 2009
Location: Prague, Czech rep.
Posts: 27
Rep Power: 18  |
Hello to FOAMing users,
may I ask you to show me how to set up case with periodic boundary condition (periodic GGI), which are implemented in OF1.5-dev. Here is typical picture (see below) with testing case. Boundary conditions are set up like this: - inlet: total pressure - outlet: static pressure - stator: wallFunctions - periodic boundary condition: something like cyclic patch, which make possible to use non-conformal. In the later, I can post some mesh on the forum, which is prepare for using periodic ggi. Many thanks in advance, David |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Periodic boundary condition | Arif | FLUENT | 3 | March 9, 2017 02:18 |
| periodic flows | Phil | FLUENT | 14 | May 16, 2013 08:21 |
| Why can't I make the boundaries periodic? | Alina | FLUENT | 5 | April 12, 2012 15:06 |
| Periodic GGI | cosimobianchini | OpenFOAM Running, Solving & CFD | 10 | August 9, 2007 05:59 |
| Must periodic oscillation give periodic results? | zonexo | Main CFD Forum | 6 | May 13, 2007 16:36 |
Linear Mode
