|
[Sponsors] |
May 27, 2009, 07:47 |
mesh squeezing
|
#1 |
New Member
andrianomena
Join Date: Mar 2009
Location: madagascar
Posts: 23
Rep Power: 17 |
Hi there,
I'm dealing with combustion modeling and it involves mesh motion manipulating.it is 2D model,for the field we have inlet,outlet,left and right symmetry plane.when the trash is burnt, it produces ashes so the volume is reduced according to the equation(mesh is squeezed): deltay = deltay*G G is a factor to be calculated in the code,deltay is the hight of the cell.the displacement is then d = delta(1-G) which is in terms of the temperature in a zone. for the pointDisplacement file we have: dimension (meter) internal field non uniform d boundary(in fact I changed the outlet patch into slip one) for the inlet I set the displacement equal to zero for the solver I set: displacementComponentLaplace y; diffusivity uniform; Would you be so kind as to tell me whether I did well? You see, I already tried a simple mesh squeezing with a simple case with a uniform displacement and it gave an error message like solver table empty............!!!!probably the displacement I put was so big!! I dont know Thanks, Regards, |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 05:27 |
virtual geometry | richard | FLUENT | 4 | January 7, 2009 06:16 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 13:21 |
How to do Geometry from 3D mesh in ICEM | San24 | Main CFD Forum | 4 | August 8, 2005 03:49 |
General questions on grid-based computing | Adrin Gharakhani | Main CFD Forum | 21 | June 5, 2000 14:47 |