Dynamic refinement on tet mesh
Good morning,
can somebody confirms if it's possible to perform dynamic refinement on a pure tet mesh (generated by gmsh) ? I'm using 1.5.x and 1.5-dev. Best regards, PO |
Are you talking about run-time refinement? Or a pre-processing step?
|
run-time ... of course :-)
cheers PO |
Yup... This has been done. Some of the work was shown at OFW Montreal:
http://www.openfoamworkshop.org/2009...idt_slides.pdf |
All times are GMT -4. The time now is 08:24. |