|
[Sponsors] |
July 1, 2009, 10:49 |
Question about term representation
|
#1 |
Senior Member
|
Hi Foamers,
I have a question concerning tensors manipulation and how to represent two terms in OpenFoam. In particular I need to do the following sum of terms: tension & grad(U) + transpose (grad(U)) & tension where tension is volTensorField. I am writing in OpenFoam exactly as I wrote before. However, I wondered if it is possible to represent the same term in the form volTensorField A = tension & grad(U); volTensorField B = twoSymmn(A); As the previous sum will give a symmetric tensor. My question is are they the same? Regards, Titio |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
Doubt in term representation | titio | OpenFOAM Running, Solving & CFD | 1 | May 7, 2009 14:38 |
question about term representation | titio | OpenFOAM Running, Solving & CFD | 0 | May 4, 2009 09:17 |
Question on term representation | titio | OpenFOAM Running, Solving & CFD | 0 | February 4, 2009 10:19 |
Question about the Wall-reflection term in RSM | Lucy | Main CFD Forum | 0 | March 3, 2007 05:31 |