Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Running, Solving & CFD

processor boundary conditions

Mark Forums Read

Reply

Search this Thread

September 5, 2009, 22:40	processor boundary conditions	#1
entitledx New Member Denis Join Date: Jun 2009 Posts: 4 Rep Power: 18	Hi everyone, I am a bit confused on what values I should put for the processor boundary conditions, and can't find any detailed information on it. I am just playing around with parallel processing on my quad core, but I am unable to actually run any solvers because they require boundary conditions for processor0To1, etc. How do these different sub domains communicate? Can I just set the processor boundary conditions to outlet conditions or will that mess everything up? Thanks!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 06:45
Implementation of boundary conditions for FVM	Tom	Main CFD Forum	7	August 26, 2014 06:58
Fluent accuracy and boundary conditions	Paolo Lampitella	FLUENT	0	June 12, 2008 07:25
Boundary conditions?	Tom	Main CFD Forum	0	November 5, 2002 02:54
A problem about setting boundary conditions	lyang	Main CFD Forum	0	September 19, 1999 19:29

All times are GMT -4. The time now is 06:46.