|June 29, 2010, 14:30||
change boundary condition on the fly
Join Date: Mar 2009
Location: State College, PA, USA
Posts: 118Rep Power: 10
It there a way to change the BC type during simulation?
I have a cavity whose top is a symmetry plane except a small patch where some fluids will be injected for 5 s. After the injection (the injecting needle will be removed), I want that small patch to be symmetry patch also.
How do I code this? Or is there a way to do it?
Right now, I have to run two simulations (with and without the injection patch) and then map the solutions.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Use DEFINE_ADJUST change boundary condition||liurengtong123||Fluent UDF and Scheme Programming||24||August 1, 2014 10:28|
|inlet velocity boundary condition||murali||CFX||5||August 3, 2012 08:56|
|Trimmed cell and embedded refinement mesh conversion issues||michele||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||2||July 15, 2005 04:15|
|Pressure Boundary Condition||Matt Umbel||Main CFD Forum||0||January 11, 2002 11:06|
|UDF, using DEFINE_ADJUST to change a boundary condition||Jonas Larsson||FLUENT||4||March 21, 2000 19:51|