Trouble with Multisolver installation...
 

Hey....i tried installing multisolver on OpenFOAM 1.7, but when try running
cd $WM_PROJECT_DIR/src/multiSolver
wmake libso

I get the message...
/bin/sh: cannot create linux64GccDPOpt/options: Permission denied
make: *** [linux64GccDPOpt/options] Error 2
/opt/openfoam170/wmake/MakefileFiles:39: linux64GccDPOpt/options: No such file or directory
make: *** No rule to make target `linux64GccDPOpt/options'. Stop.
wmake error: file 'Make/linux64GccDPOpt/objectFiles' could not be created


Can u help me with this, I think it is due to a permission issue, but ane idea, how i can go past tht???

I would be thankful if you could tell me tht...

Spamming has to be fun! :mad: You asked the same question in three threads.

Apologies!!!
 

Sry abt tht...didn't want to do tht...but i just wanted a quick reply....won't do tht again!!!

Fine :)

It seems you are using the Debian/Ubuntu packages, or an installation out of your /home, so you do not have write permission there.

You can probably fix this by setting the destination of multisolver in your local OpenFOAM directory (FOAM_USER_APPBIN) in the Make/files file.

Best,

What is Multisolver
 

Hi
I have a primary question.
Would you explain me what is Multisolver?
Thanks a lot
Best regards

Ata

Hi Ata,
It was released a little over a week ago: http://www.cfd-online.com/Forums/ope...-released.html

Best regards,
Bruno

Thanks
 

Hi Bruno
Thank you very much.
Best regards

Ata