 |
 |
 |
|
|
|
[Sponsors] | ||||
How can I see the actual mesh motion in mixer vessel? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 15, 2010, 18:56
|
How can I see the actual mesh motion in mixer vessel?
|
#1 |
|
Member
|
Hi everyone,
I changed the geometry in the MRFSimpleFoam/mixervessel2d tutorial in OF 1.7.1 (see attached image) and I would like to see the actual mesh motion. I want to see the rotor (center square) in a different angular position at each timestep. Is that possible? Thanks! |
|
|
|
|
|
| Tags |
| dynamic mesh, rotating boundary, topology change |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 20:43 |
| Mesh motion on inlet (2-way FSI) | Lance | CFX | 2 | August 13, 2009 06:31 |
| unusual mesh motion...............help me out | samad87 | FLUENT | 1 | August 10, 2009 02:02 |
| mesh motion | samad87 | FLUENT | 0 | August 6, 2009 04:15 |
| Mesh motion Hex cells vs tets | kev4573 | OpenFOAM Running, Solving & CFD | 6 | December 13, 2007 15:37 |
Linear Mode
