|
[Sponsors] |
January 20, 2011, 06:25 |
What does wrongOrientedFaces means?
|
#1 |
Senior Member
|
Hi Foamers,
I found a checkMesh error with meshes generated with snappyHexMesh + snapEdge (by Niklas Nordin). It complains with some wrongOrientedFaces (not too much, allways around 30). What does this error means? It is possible to correct it as a postprocessing using some meshing tool? And if not, could it corrupt the solver's results, or it is ok to run with this error? Thanks, Ivan |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
error means? | hanid | Main CFD Forum | 0 | September 8, 2008 14:25 |
what's couple in wall boundary conditions means? | eve | FLUENT | 1 | July 23, 2007 13:20 |
BC evaluation by means of external lists allocated in the solver | shrina | OpenFOAM Running, Solving & CFD | 2 | January 18, 2007 12:29 |
What does the floating point error means? | jon william | FLUENT | 1 | October 8, 2006 09:57 |
What means % in Fortran? | What means % in Fortran | Main CFD Forum | 2 | April 20, 2004 15:34 |