 |
 |
 |
|
|
|
[Sponsors] | ||||
March 7, 2016, 03:25
|
non-matching boundary problem
|
#1 |
|
New Member
A Z
Join Date: Dec 2015
Posts: 16
Rep Power: 10  |
Hey,
I have a problem matching two cellzones. My geometry is a rotor-impeller combination. The rotor has two blades and the impeller seven. I just want to simulate the half rotor and one seventh of the impeller. Is there any way to use the cyclicAMI boundary condition? Regards |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low torque values on Screw Turbine | Shaun Waters | CFX | 34 | July 23, 2015 08:16 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
| domain imbalance for enrgy equation | happy | CFX | 14 | September 6, 2012 01:54 |
| [GAMBIT] 3D boundary layer and meshing problem in GAMBIT 2.4.6 | prashanthreddyh | ANSYS Meshing & Geometry | 1 | December 20, 2011 00:35 |
| Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Linear Mode
