 |
 |
 |
|
|
|
[Sponsors] | ||||
November 30, 2011, 12:40
|
Help with Running Simulation
|
#1 |
|
New Member
Join Date: Oct 2011
Posts: 3
Rep Power: 14  |
Hello!
I'm trying to run a simulation of the flow around a block. I am using icoFoam to do this; however, when I run my simulation the courant number blows up really quickly and I am not sure why this is happening. I have posted the setup files and would really, really, really appreciate any insight as to what I am doing wrong! I couldn't provide the neighbour file as it was too large, but would be happy to do that if necessary. Thank you so much! 
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| velocity profile export from a simulation onto another | sudhirlv | STAR-CCM+ | 1 | September 12, 2010 18:57 |
| Trying to stop CFX running mannually | cfxmar | CFX | 8 | August 27, 2010 11:00 |
| Running Multiple Simulations from Workbench 12.1 | Josh | CFX | 3 | August 10, 2010 19:51 |
| Steps to be completed before running the simulation | Saha_AIT | STAR-CCM+ | 3 | December 1, 2009 10:54 |
| Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 13:46 |
Linear Mode
