|April 3, 2012, 14:54||
Obtain values only at boundary during a run
Join Date: Mar 2012
Posts: 6Rep Power: 7
For my own solver, I need to store only the pressure values at the wall (walls as specified in constant/polyMesh/boundary). This is then used as a source term for dipoles aeroacoustic sources.
I was thinking to store a new volScalarField, with the values for p on the boundary for each time step. The internal field should be zero then.
Is there a simple command to only obtain the boundary values of a volume scalar field, while the internal field should be empty/zero?
Thanks in advance,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|Use sampled data from previous run as boundary condition for new setup||Arnoldinho||OpenFOAM Running, Solving & CFD||3||December 6, 2012 14:16|
|boundary values||OFU||OpenFOAM Programming & Development||4||August 9, 2011 06:27|
|How have boundary values set for calculated variables||olwi||OpenFOAM Running, Solving & CFD||5||August 25, 2006 11:56|
|Turbulence boundary values||lego||Main CFD Forum||0||October 24, 2002 13:47|